Problem: -V80 machine starts mopping but unable due to the cloth is not getting wet, and displays an E- 33 error on the screen.
Reason: - Mainly the water tank is to keep the mopping cloth wet during cleaning but, Sometimes during mopping, the tiny dust or the detergent particles got stuck in the water tank hole, which blocks the way of the hole from which the mopping cloth gets wet.
Solution: - Please follow the steps given below:
1. Please turn off the machine.
2. Press the water tank holder gently, and take out the water tank.
3. Remove the mopping cloth & check whether water is leaking from the hole or not.
4. If not take a safety pin, and put in the hole & rotate the pin to remove the stuck dust particle. There are 3-4 holes to-do the same with all, without any extra pressure and clean that area with a cloth.
5. Avoid the use of detergents in the water tank.
6. Now check whether water is coming from the holes of the water tank, as shown below In the video.
7. Stick the cloth to the water tank & you are ready to use the machine.
For wet cleaning, V7s plus uses i-dropping technology in which it sprinkles the floor. To ensure thorough wet cleaning, water tank must be inserted properly. There are four simple steps to insert water tank. There are four simple steps to insert ...
V5s Pro works on i-dropping technology. However, continuous usage over long time and dirty floors may lead to blockade of ducts and water tank may stop dispensing water. In that case, water tank needs to be cleaned. Water tank can be cleaned in three ...
Problem: Recently purchased machine and one of the cleaning brush got stuck at one side. Machine throws error with red light and E14 displayed on LCD Screen.. Reason: Function of side brushes is to bring all the dust on both corners in center of the ...
Problem: The Vacuum Cleaner works fine for 5-10 minutes but after some time it gives beep and stops with an error on LCD Screen as E12. Reason: Sometimes a small/soft piece of paper or thread get tangled around the roller wheel, which stops it from ...
With prolonged and continuous usage on marble floor, the friction in the wheels may be reduced and wheels become slippery. In this case, rub a sand paper very gently on both the wheels. It helps in cleaning the wheels and resuming wheels its normal ...