Side Brush not Rotating - E14

Side Brush not Rotating - E14

Problem: Recently purchased machine and one of the cleaning brush got stuck at one side. Machine throws error with red light and E14 displayed on LCD Screen..

Reason: Function of side brushes is to bring all the dust on both corners in center of the suction port, to create cyclone cleaning pattern. If any of the side brush stops, machine throws error 14.

Solution: This is a general error, as Vacuum Cleaner will try to clean dust, however it gets tangled with Human Hairs or other threads.

  1. To solve the problem, please turn off  the Machine       
  2. Kindly Check the Right Side Brush of the Robot for any threads, Hair or wires  tangled over the brush.  .   
  3. Snap Out both brushes from the Robot using both hands. Clean the brush and  remove any hair tangled in or around brush. Replace it back on the Robot and start the Robot.
  4. Unscrew the cap, with a screw driver, as shown below & clean any hairs tangled. Screw it back.
  5. Snap in both brushes and start the machine.

Play below video, for step by step instructions:




    • Related Articles

    • Voice Message -' Please check the Main Brush' - Bristle/Silicon Brush

      Problem: A Voice message on A9s machine, saying to check the Bristle or Silicon brush. Reason: During general cleaning, a large thread or loose wires like speakers, iron, threads lies on the floor. While cleaning any of such wire rotates on the edge ...
    • Voice Message -' Please Check the Side brush' - Left or Right

      Problem: A9s machine stopped with an error as to check the left or right side brush.  Reason: The machine is intelligent enough to give a voice message if it gets stuck due to any reason. With human hair falling on ground generally it gets stuck on ...
    • Bumper Stuck from One Side of Unit - E23

      Problem:- Whenever V80 machine is switched on, it starts, goes few step and then come back and stop.  Reason: In daily cleaning routine, sometimes a thread or some dust get stuck on bumper. Due to this 1 side of the bumper is pressed and does not ...
    • Right or Left Wheel of the cleaner is Jammed - E12

      Problem: The Vacuum Cleaner works fine for 5-10 minutes but after some time it gives beep and stops with an error on LCD Screen as E12. Reason: Sometimes a small/soft piece of paper or thread get tangled around the roller wheel, which stops it from ...
    • V8s Machine Starts, Moves few steps, comes back and Stops - E22

      Problem: V80 machine initiate from docking station, starts & run few steps, then come back and stops. Reason: There are 11 sensors under each ILIFE vacuum cleaner that helps it to navigate to different direction or detects stairs to move back. During ...