Voice Message -' Please check the Main Brush' - Bristle/Silicon Brush
Problem:
A Voice message on A9s machine, saying to check the Bristle or Silicon brush.
Reason:
During general cleaning, a large thread or loose wires like speakers, iron, threads lies on the floor. While cleaning any of such wire rotates on the edge of bristle or a silicon brush. This stops the bristle brush to rotate.
Solution:-
Please turn off the Machine and put it upside down
Open the yellow cover by pressing the lock.
Remove the side brush. You will see lot of hair tangle around it.
Don't try to remove hair or thread by hand as you might either hurt your hand or cut the silicon brush. Instead take a scissor and cut the unwanted hairs to remove them.
We recommend to put a sewing oil, on the corners of the rotating brush, like WD40. This helps in removing the moisture on the side brushes motor. WD40 is generally available at hardware shops or on amazon. Please ask ILIFE representative to help you, in case no available.
Put back the roller brush, and close the yellow cover, as shown below.
Problem: A9s machine stopped with an error as to check the left or right side brush. Reason: The machine is intelligent enough to give a voice message if it gets stuck due to any reason. With human hair falling on ground generally it gets stuck on ...
Problem: Recently purchased machine and one of the cleaning brush got stuck at one side. Machine throws error with red light and E14 displayed on LCD Screen.. Reason: Function of side brushes is to bring all the dust on both corners in center of the ...
Problem: A voice message comes, please check the right or left wheel. Reason: During daily cleaning, sometimes a tissue paper/napkin get stuck on Right or Left wheel of machine, due to which it get jammed. If you try to rotate with hand, it will not ...
Problem: A Voice Message ' Please check the Universal Nose Wheel'. Reason: Nose wheel is the free 360° rotating wheel to maintain the balance and give right directions to robotic cleaners. Solution:- Here are the steps: Please Turn off the Machine ...
Problem: Machine moves few steps and then stops, considering there is an edge. Reason: While moving machine manual through hand from 1 location to other location, the underneath sensors get hand print or dirt. Robotic Cleaner, take that as dark area ...