V8s Machine Starts, Moves few steps, comes back and Stops - E22
Problem: V80 machine initiate from docking station, starts & run few steps, then come back and stops.
Reason: There are 11 sensors under each ILIFE vacuum cleaner that helps it to navigate to different direction or detects stairs to move back. During dust cleaning, sometime a Dust stuck on any of the sensor & it senses it to be stair & Move back.
Solution:- Please Turn off the Machine and put it upside down, as shown in video
● Take a clean dry cloth and try to clean all sensors to remove any dust or any mark on it.
Problem: Recently purchased machine and one of the cleaning brush got stuck at one side. Machine throws error with red light and E14 displayed on LCD Screen.. Reason: Function of side brushes is to bring all the dust on both corners in center of the ...
Problem:- Whenever V80 machine is switched on, it starts, goes few step and then come back and stop. Reason: In daily cleaning routine, sometimes a thread or some dust get stuck on bumper. Due to this 1 side of the bumper is pressed and does not ...
Problem: The Vacuum Cleaner works fine for 5-10 minutes but after some time it gives beep and stops with an error on LCD Screen as E12. Reason: Sometimes a small/soft piece of paper or thread get tangled around the roller wheel, which stops it from ...
Problem: A Voice message on A9s machine, saying to check the Bristle or Silicon brush. Reason: During general cleaning, a large thread or loose wires like speakers, iron, threads lies on the floor. While cleaning any of such wire rotates on the edge ...
Problem: Machine moves few steps and then stops, considering there is an edge. Reason: While moving machine manual through hand from 1 location to other location, the underneath sensors get hand print or dirt. Robotic Cleaner, take that as dark area ...